The function of the balance bar is that when the level of the left and right wheels are different, in order to prevent the shaft from twisting, the balance bar will generate Roll Resistance to prevent the body from rolling. That is, the balance bar will not work when the left and right suspensions move synchronously up and down. The balance bar will only work when the left and right suspensions move out of sync due to road undulations or turning and cornering.

The effect of the balance bar is shown in the roll when cornering. The way to understand the degree of roll is to use a camera to take a photo of the corner, and then measure the roll angle on the photo, and replace it with a stiffer balance bar. Take another shot in the same way and compare the two angles to determine the difference. It is very complicated to calculate the hardness of the required balance bar. Not only must the hardness of itself be considered, but the combination with the spring must be considered. Therefore, it is the only way to test and test continuously. This is the only way to set the chassis.

Precautions

Cars should be equipped with stabilizer bars reasonably: For many people, the stabilizer bar is just an inconspicuous iron rod, but you may not know that this iron rod will have a significant impact on your car, but you have never understood its function .

1. The function of the balance bar When the left and right wheels travel on the same road bump or hole, the balance bar does not have any effect. However, if the left and right wheels pass through different road bumps or holes, that is, when the level of the left and right wheels are different, it will cause the shaft to twist and produce anti-roll resistance (Roll Resistance) to prevent the body from rolling. That is to say, the balance bar will not work when the left and right suspensions move synchronously up and down, and the balance bar will only work when the left and right suspensions move out of sync due to road undulations or turning and cornering. The balance bar will harden the road performance only when it acts, unlike a hard spring that will harden the road performance as a whole. If you want to completely rely on springs to reduce the body's roll, you may need very hard springs, and moreover, use shock absorbers with a high damping coefficient to prevent springs from bouncing. In this way, we should bear hard springs and shock absorbers. The sequelae caused by the device such as road performance and poor tracking performance when walking on uneven roads. However, if you match the appropriate balance bar, you can not only reduce the roll, let alone sacrifice the comfort and tracking that it should be. Therefore, the combination of the balance bar and the spring is a feasible way to achieve a compromise between travelability and maneuverability.

2. Note: The balance bar is not randomly added. You must be optimistic about the texture and workmanship.-The balance bar does not mean that the higher the strength, the better, it does not mean that the more tough the better, the higher the strength, the longer the time will be. You hang on it, which is the position where you install the balance bar to make a hole in the body, and it deforms (because the balance bar is too rigid, the distortion produced when cornering at high speed cannot allow the toughness of the balance bar to remove this force, so this force is It deforms the body, because the steel plate of the body is relatively softer). However, a balance bar that is too soft cannot improve the rigidity of the body, so it can be said to be a decoration.